Cleaning A Faucet Aerator: Simple Plumbing Cleaning Chore

Mr Rooter Tip Of The Day: Though a pick-and-hook set is best for cleaning small parts, you can improvise with tiny screwdrivers or needles.
Faucet Aerator

Pittsburgh, Pennsylvania (PRWEB) September 11, 2012 -- Faucet aerators mix air with the water, minimizing splashing and reducing the amount of water used (and the energy required to heat hot water) without reducing the effectiveness of the water stream. “An aerator contains a screen and a water reducer/aerator washer,” according to Bob Beall, the most referred plumber in the Northeast Ohio and Southwest Pennsylvania region. According to Mr Rooter, “these little items have a habit of collecting bits of naturally occurring mineral sediment in the water.” Mr Rooter’s Tip Of The Day is delivered directly to your inbox daily from master plumber and president of Mr Rooter Plumbing Pittsburgh/Youngstown. Beall’s family owned and operated business serves 2.9 million residential and commercial customers, offering a free second opinion on any plumbing repair job.

“What becomes noticeable when the aerator becomes clogged is a reduced water flow at the spout (on both hot and cold) and/or a non-symmetrical spray coming from the spout,” according to Beall.

Mr Rooter’s Tip Of The Day

  • Tip #1 To remove the aerator from the faucet simply turn it counterclockwise. Drop it straight down so you don’t lose any internal parts, especially the thread-sealing gasket. The threads can be either inside or outside the cap. If the cap is stuck, you will need pliers to turn it.
  • BONUS TIP: Tape the jaws with electrical tape to minimize scratching).
  • Tip #2 Look inside the center area for sand, silt, and other waterborne debris.
  • Tip #3 Take the center section out to check for further debris, noting the order in which things come apart.
  • Tip #4 Check for anything stuck in the screen.
  • Tip #5 In the flow reducer, look in the tiny side holes and the center hole of the white button for debris.
  • Tip #6 If you do not put all the pieces back together properly, there will be a leak or the water flow will not be a smooth aerated flow.

WHAT CAN GO WRONG: Despite even the most experienced plumber’s intentions, it’s easy to let the parts of an aerator fall out when removing it. To prevent permanent loss of any parts, put the stopper in the sink drain before removing the aerator. If it is necessary to take the aerator away from the sink, to keep from losing parts, disassemble it over a bowl.

Mr. Rooter’s Daily Tips are provided by Mr. Rooter Plumbing. Subscribe today! (top right corner) Visit our Facebook page!

There’s A Reason They Call Us Mr.™
Call for a free second opinion on your next plumbing repair job!

Debra Santavicca PR, SMM, WebIT
Mr. Rooter Media Center


Related Blog Articles: 

Add new comment